|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Does anyone know this setup posted by jrubin on August 23, 2015 at 15:41:09:
Each output tube should see about 50mA cathode current. With 10 ohms resistors in the cathode of each tube that equates to 0.5V (across each resistor). If you want to run a different current (don't go above 60mA) you can calculate the voltage V=current * 10
(current is in amps in this formula)
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re:Does anyone know this setup - Joe Curcio 17:47:23 08/23/15 (4)
- Re:Does anyone know this setup - jrubin 15:54:42 08/24/15 (3)
- Re:Does anyone know this setup - jrubin 15:55:31 08/24/15 (2)
- Re:Does anyone know this setup - jrubin 16:54:50 08/24/15 (1)
- Re:Does anyone know this setup - jrubin 17:16:00 08/26/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
