In Reply to: Fuse for PAS-2 Transformer Replacement posted by patknk939 on May 9, 2015 at 15:52:48:
Hi 1973Shovel. I checked the bottom of the cap board. While the trace from "out to xfmr" runs the same way as you indicated, the trace from "120V in" is not. It runs to the small capacitor (right next to the fuse) that connects to the fuse. As for the half-amp fuse, I don't know why it is not the 300mA as the schematic shows. The fuse is there when I bought the board. In fact, the two caps (rectangular ones on left of the schematic) on the actual cap board are each 0.22uf, not 0.1uf showed.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Fuse for PAS-2 Transformer Replacement - patknk939 12:43:57 05/12/15 (3)
- I'd say you're good to go - 1973shovel 14:04:01 05/12/15 (2)
- RE: I'd say you're good to go - patknk939 19:02:52 05/12/15 (1)
- If it were me - 1973shovel 04:43:49 05/13/15 (0)