|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Input capacitance of PAS phono board (stock) posted by Wanderer on January 18, 2015 at 11:03:38:
Your phono cable is also in the capacitance equation. Might so small it's insignificant though. The cartridge spec sheet should tell you the total input capacitance. Whatever the wires measure subtract that from the spec sheet and just add in the difference.
Just looked up the specs and it says nothing about capacitance loading. The loading is 47K ohms on the input. Standard MM cartridge specs.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Input capacitance of PAS phono board (stock) - xaudiomanx 21:52:37 01/19/15 (1)
- RE: Input capacitance of PAS phono board (stock) - Wanderer 06:22:55 01/20/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
