Noticed the Pas 2 repair guide does not have an active link.
I have a Pass 2 that has a short somewhere. The amp caused a very loud buzzing, which to me sounded like a short. It stopped making sound and the transformer then almost immediately started getting super hot.
I did some quick measurements on the tubes - the 6v filament supplies were good but all else were at 0 volts. A visual inspection did not give any clues as to what burned, although the smell of burnt electronics was pretty obvious.
Given I have a trans gets super hot super quick, I don't want to try and track the voltage with a multi meter. Are there any components that tend to fail/short that is worth looking at first?
Thanks much
Cleet
This post is made possible by the generous support of people like you and our sponsors:
Topic - Pas 2 repair guide? - Cleet Torres 17:24:57 04/21/14 (1)
- RE: Pas 2 repair guide? - petercapo 18:02:12 04/21/14 (0)