In Reply to: Perhaps Joe could offer a comment, but here’s what I have found... posted by petercapo on March 24, 2014 at 07:21:34:
Bypassing the balance pot is relatively simple - as you outlined. In effect, connecting the center lug wire to the hot outer lug of each section of the balance pot (and reming them both from the balance pot) is all that is needed. There is no need (nor is it desired) to add a resistor to simulate the load of the balance pot (the less loading the better with the PAS outputs)
I cannot comment to the distortion you observed afterwards - there should be little or no audible change (any would be to the better).
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Perhaps Joe could offer a comment, but here’s what I have found... - Joe Curcio 07:51:54 03/24/14 (1)
- RE: Perhaps Joe could offer a comment, but here’s what I have found... - petercapo 08:20:37 03/24/14 (0)