A friend of mine has a Dynaco Pass 2 pre. The balance control has gone south on his unit. To get him going, I was thinking to just bypass the balance control pot.
Bearing in mind I have zero knowledge or experience on Dynaco gear, is there anything I need to do like replace pot with a resistor of some value when I bypass?
Advice appreciated
Regards
Cleet
This post is made possible by the generous support of people like you and our sponsors:
Topic - Pas 2 balance bypass - Cleet Torres 12:14:34 03/22/14 (10)
- RE: Pas 2 balance bypass - Cleet Torres 11:26:34 03/24/14 (4)
- RE: Pas 2 balance bypass - Flyquail56 15:35:48 03/29/14 (1)
- RE: Pas 2 balance bypass - Cleet Torres 09:39:41 03/30/14 (0)
- RE: Pas 2 balance bypass - petercapo 19:05:57 03/27/14 (1)
- RE: Pas 2 balance bypass - Cleet Torres 17:09:57 03/28/14 (0)
- RE: Pas 2 balance bypass - Joe Curcio 09:24:55 03/24/14 (1)
- RE: Pas 2 balance bypass - petercapo 09:44:51 03/24/14 (0)
- Perhaps Joe could offer a comment, but here’s what I have found... - petercapo 07:21:34 03/24/14 (2)
- RE: Perhaps Joe could offer a comment, but here’s what I have found... - Joe Curcio 07:51:54 03/24/14 (1)
- RE: Perhaps Joe could offer a comment, but here’s what I have found... - petercapo 08:20:37 03/24/14 (0)