In Reply to: RE: One more question regarding MK3 Cap Upgrade posted by rockpassion on March 7, 2014 at 15:09:59:
I would have to know the values of each section, unless they all measure the same. If they don't then I would have to say the section with the lowest value in UF would go to pin 8 of the rectifier(that really should not be more than about 40UF or so), the next highest value would go after the choke and the last two(if they are equal in value) would go to the last two spots. I would also think you could just match the corresponding letters. And yes, the ground goes to where the center tap of the B+ goes, usually on star ground.
Why did you change the board if there was already an upgraded one in there?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: One more question regarding MK3 Cap Upgrade - xaudiomanx 17:16:00 03/07/14 (1)
- RE: One more question regarding MK3 Cap Upgrade - rockpassion 18:29:50 03/07/14 (0)