In Reply to: RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover posted by aguaazul@gmail.com on February 4, 2014 at 10:43:19:
No.... loading resistors are used to provide proper termination for the PAS with the stock tone controls to operate correctly when the preamp sees a 100K ohm load. They don't offer more drive current - IOW lower source impedance
There is no way to modify the existing circuit (without changing stage 2 to a CF) to lower the Zout
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - Joe Curcio 10:55:48 02/04/14 (4)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - petercapo 13:11:11 02/04/14 (1)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - Joe Curcio 14:30:38 02/04/14 (0)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - aguaazul@gmail.com 11:24:08 02/04/14 (1)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - Joe Curcio 11:59:11 02/04/14 (0)