In Reply to: RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover posted by petercapo on February 4, 2014 at 06:23:41:
Thanks for the quick reply. Well Joe Curcio did his magic on this PAS3. I'll look to see if that cap is i there, but I think it was just bypassed using he bypass method, not sure if I had the x-mod done. Is there any way with some parallel resistor math magic, could I get the minimum input impedance down to 50K?
There is no level control in the x-over.
Randall Nerison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - aguaazul@gmail.com 08:39:23 02/04/14 (2)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - petercapo 08:51:58 02/04/14 (1)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - aguaazul@gmail.com 10:12:20 02/04/14 (0)