|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: st=70 load resistors posted by GP49 on October 9, 2013 at 10:50:44:
not much said but then a lot said!
The load should be carried respectively,does this not make sense?
modern equipment has this particular load,it's the early iron that loads up at higher ohms.Does it make sense to adjust the load accordingly?
THANKS,AND ANY INPUT ON THIS IS WELCOMED
GRUNT
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: st=70 load resistors - Camrahnbay 16:19:50 10/09/13 (4)
- RE: st=70 load resistors - GP49 16:46:01 10/09/13 (3)
- RE: st=70 load resistors - Camrahnbay 19:54:22 10/15/13 (2)
- RE: st=70 load resistors - GP49 20:56:09 10/15/13 (1)
- RE: st=70 load resistors - Camrahnbay 21:14:00 10/15/13 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
