In Reply to: RE: help with Dynaco Pas line stage circuit check posted by gdlen1@yahoo.co.nz on May 4, 2013 at 06:11:51:
Hi again, the confusion on my part is this, the original Curcio tone removal instruction say to jumper BOTH of the original .0075 caps with wire, and some other people say to install a cap up to 1uf so that there are two output caps in series after the second half of the tube to stop DC as apparently one was not enough, maybe thats why Dynaco changed the cap from .02 to .22
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 06:31:08 05/04/13 (7)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 16:35:51 05/04/13 (6)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 16:42:36 05/04/13 (5)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 21:50:50 05/04/13 (4)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 16:56:14 05/06/13 (3)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 21:39:30 05/06/13 (2)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 05:14:06 05/07/13 (1)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 05:23:06 05/07/13 (0)