Home Dynaco-Doctor Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

Dynaco 400 amplifier problems,

Hello, I a new to this forum and I would appreciate any help you may give me regarding a problem I have with the above amplifier.

I have acquired a Dynaco 400 stereo amplifier and it has some problems. Upon pulling off the top cage cover and before plugging it in to my dim bulb tester I noticed it had a transistor that was hanging off the PC-29 board on the very top by one metal leg only. I looked at the service manual and it was labeled Q6 on page 39. Upon searching for the part number I could not find it listed. Then I noticed on the schematics of the board in small print it stated "PC-29 Add 100 to all component numbers". I searched again and on page 23 found the number Q106 a transistor MPSU56 and the part number 567043.

Am I correct in assuming this is the correct transistor to replace the one that is hanging off? There are no numbers on the one in the amp. I really can't go any further until I replace this part. I also plan on re-capping it.



This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Topic - Dynaco 400 amplifier problems, - daveyhockett 05:50:18 02/21/12 (18)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.