|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: PAS Volume Pot Problem posted by Ross on February 12, 2012 at 07:20:15:
That replacement will do fine, but you may want to try disconnecting everything from the loudness tap, first. If those parts go off value, they can cause a large balance shift just as the volume control wiper passes the spot where the loudness tap is.
I assume you have already tried cleaning the volume pot...
If you do replace the pot, all you have to do is leave the loudness circuit parts disconnected from the pot entirely. You do not need to do anything else. They will be out of circuit.
GP49
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PAS Volume Pot Problem - GP49 12:20:57 02/12/12 (9)
- RE: PAS Volume Pot Problem - Ross 13:24:41 02/12/12 (8)
- RE: PAS Volume Pot Problem - GP49 15:22:44 02/12/12 (7)
- RE: CAE PC-7A output wiring questions - Joe Curcio 18:16:46 02/12/12 (6)
- RE: CAE PC-7A output wiring questions - GP49 19:36:12 02/12/12 (5)
- RE: CAE PC-7A output wiring questions - Joe Curcio 15:52:05 02/13/12 (4)
- RE: CAE PC-7A output wiring questions - Flyquail56 19:17:40 02/26/12 (0)
- RE: CAE PC-7A output wiring questions - GP49 16:38:08 02/13/12 (2)
- RE: CAE PC-7A output wiring questions - 54dynaco 09:16:58 05/11/12 (1)
- RE: CAE PC-7A output wiring questions - GP49 22:44:24 05/11/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
