|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Need Help with Wierd Voltage Readings posted by Dawg on March 23, 2002 at 20:25:04:
It looks like the C4S modules are not providing current to the tubes, so there is something wrong with them. Yes, both LEDs should glow on each module.First check - are you using the magnet wire to install the C4S boards? If so, there may be a poor connection if the insulation is not burned off completely.
You might consider removing the C4S boards and returning to the stock configuration - that way you'll have sounds, which is rewarding and encouraging. Then you can go over each C4S carefully and liesurely while you have some tunes. First, check that each resistor is the right value - it's easy to miss-read the color code, they are pretty small. The make sure the LEDs are installed in the correct direction. Then the transistors. Post if you find any errors, and we'll help figure out if any parts have been damaged or not.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Need Help with Wierd Voltage Readings - Paul Joppa 22:25:43 03/23/02 (2)
- Re: Need Help with Wierd Voltage Readings - Dawg 19:17:16 03/24/02 (1)
- High volts no problem (nt) - Paul Joppa 22:36:30 03/24/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
