|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Paramour Construction Question - transformer bolts too short! posted by Vinyl_Junkie on April 22, 2001 at 15:04:14:
With the bushings and lock washers, some nuts will be hard to start on the screw threads. Don't force it. That is a good way to cross thread the screw. To fix this, take the lock washer off, gently start and then tighten the nut (but not all the way tight - no grunting allowed when tightening!). After the nut is tight, take the nut off. This will compress the bushings and any paint build up on the chassis and transformers. Now you can put the lock washer on the screw thread and properly tighten the nut.As you tighten the nuts, make sure the bushing is properly seated in the mounting holes and is not just getting crushed.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- The nuts won't start on the screw! - VoltSecond 15:25:32 04/22/01 (4)
- There just isn't enough bolt to work ... - Vinyl_Junkie 09:03:34 04/23/01 (3)
- Re: There just isn't enough bolt to work ... - johng 19:24:04 04/23/01 (0)
- Re: There just isn't enough bolt to work ... - boatshed 10:19:42 04/23/01 (0)
- Yep...looks like you will need longer bolts for sure - RBP 09:51:18 04/23/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
