|
Bastanis DIY Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bastanis DIY Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Re: Bastanis posted by Robert Bastani on October 30, 2006 at 09:32:40:
Thx.
I have previous experience with an MLTL with this dimms....18"(wide)16,5"(deep)x45"(high) with an port 5" dia. put on the 3" distance from the bottom (lenght is 1"-to 3").The driver is mounted on the 8" (center of driver) from the upper.The damping material is on 30" fill from the upper panel.
So ...that is big enclosure.But is not that stomach hammer punch...you know...that is missing.I compare that with my small Technics (6,5" middle bass driver) in bass-reflex enclosure.On that speakers the bass shaking the floor but lack in details,voices and instruments.
The burn in perioud is probabily an issue?
My driver have an fs=52hz,qts=0,53 and an xmax.=4mm.
If I made an open baffle probabily I cutt on 200-300hz with an active sub.The Supravox will be free ...without any filter.
The amp from the sub. will have phase pot.(0...180 degree),cutt-off pot. 4th order Linkwitz pot. gain switch(x10) and volume potentiometer.
What do you think?
The Dragonfly ...I don't know what kind of enclosure is ...but I think is something in between Voigt and backloaded horn.
Do you think if I build the Dragonfly will have more bass comparing with my huge MLTL?
Please advice me to choose the right driver for an good sub. and if you could ...more details about Dragonfly enclosure?
Thx.
Vali
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Bastanis - carceivasile@yahoo.com 23:14:15 10/30/06 (1)
- Re: Bastanis - Robert Bastani 00:17:56 10/31/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
