Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Headphone/Speaker Out from Cathode Follower Preamp posted by Palustris on September 30, 2020 at 08:08:44:
I apologize for not being clear enough.
As there is much discussion here about headphone amplifiers, I was looking for a way to take the 160volts from the tone stack cathode follower and input it into a DIY headphone amp with a headphone/speaker output of 5 ohms as is used by the old classic iPods.
Rob Robinette alread has designed schematics and chassis layouts for a 1 watt speaker tube amp that has a headphone out. I was looking for more information on how specifically to get that 5 ohm headphone out that works for both small speakers and headphones before I dive into laying out and buying components for a DIY tube amp.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Headphone/Speaker Out from Cathode Follower Preamp - Joe_S 11:26:24 10/02/20 (1)
- RE: Headphone/Speaker Out from Cathode Follower Preamp - Palustris 13:59:15 10/02/20 (0)