Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Specs posted by JURB on March 12, 2019 at 14:45:15:
1500uF won't be 3dB down at 20Hz into an 8 ohm load, probably closer to 2dB ;)
If you put signal in after the tone controls, how is the FR then? I sure would be measuring the resistors and caps in the tone circuit, there are probably a lot of 10% parts floating around in there. I don't think anybody would be offended if you just bypassed the tone control circuit.
This post is made possible by the generous support of people like you and our sponsors: