|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Multimeter with max voltage hold posted by PaulF70 on July 16, 2017 at 06:41:28:
You might want to use a single sinewave for your measurement as capturing AC across a broad complex audio spectrum will require more than just a multi-meter. Many are good to about 1-KHz (1-ms) and some higher end models (that triode mentioned) are good only to about 4-KHz (250-uS).BTW the decades old Fluke 187 & 189 were replaced years ago with with the Fluke 287 and 289 but these are in the $450 - $600 range.
The Fluke 87 V (5th gen) is around $350 - $400.
Some lower cost models that measure True RMS AC may do what you want. In Fluke terminology look for features like Min/Max, AutoHOLD, Fast Min/Max.
Edits: 07/16/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Multimeter with max voltage hold - AbeCollins 12:03:40 07/16/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
