Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
I've designed a circuit that I've already had tested it on breadboard and it has worked fine. When I did it on a PCB a new issue has appeared. The voltage regulator (I'm currently using a 7805) gives right values at no load, but when I attach the Atmega328 on it the output voltage goes to 1V instead of 5V and input goes to 2.5V, instead of 12V at no load. I've already try to change the capacitors. As specified on DS, after rectify it I put a 330nF on INPUT and another of 100nF on OUTPUT, both ceramics. Can someone, please, figure out what's going on?
Here is the datesheet of lm7805:http://www.componentschip.com/details/ST/LM7805.html
This post is made possible by the generous support of people like you and our sponsors:
Topic - LM7805 voltage drop when attach load - makiyang614@gmail.com 20:43:55 06/25/17 (5)
- RE: LM7805 voltage drop when attach load - Palustris 08:02:47 06/26/17 (0)
- RE: LM7805 voltage drop when attach load - airtime 06:55:52 06/26/17 (0)
- RE: LM7805 voltage drop when attach load - AbeCollins 05:18:44 06/26/17 (0)
- RE: LM7805 voltage drop when attach load - fredtr 04:49:48 06/26/17 (1)
- RE: LM7805 voltage drop when attach load - fredtr 13:47:50 06/26/17 (0)