Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: I'm not sure posted by Ugly on June 2, 2017 at 10:26:03:
Just use ground as a reference for the servo, so the DC output is 0V.
As far as the input, each preamp side will have its own resistor to ground so that the preamp can function; that value should be 23.5K so that the load on the cartridge is 47K.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I don't think you need to do that - Ralph 10:51:51 06/02/17 (5)
- RE: I don't think you need to do that - Ugly 09:30:52 06/03/17 (4)
- Are you building a preamp from scratch then? nt - Ralph 08:52:04 06/05/17 (3)
- RE: Are you building a preamp from scratch then? nt - Ugly 19:21:24 06/05/17 (2)
- Ahhh Day dreaming the ? - bare 16:29:23 06/11/17 (1)
- RE: Ahhh Day dreaming the ? - Ugly 11:33:40 06/13/17 (0)