Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Now that I've read your post, I realize where I made a mistake... posted by Ugly on May 30, 2017 at 20:19:13:
You don't need to rewire anything on the Technics SL1200. All you have to do is construct a different cable to go from the arm to the preamp.
The specs for doing this is in the owner's manual for our preamps which is a free download- but the important thing is that you don't allow the barrel connection of the RCA to come in contact with the shield of the cable, which ties to the ground post on the 'table, and to pin 1 of the XLR input on the preamp side (which is also ground).
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I forgot to mention - Ralph 09:25:17 05/31/17 (3)
- RE: I forgot to mention - Ugly 10:09:32 05/31/17 (2)
- Is that noise there when the input is connected to the cartridge? nt - Ralph 11:10:31 05/31/17 (1)
- RE: Is that noise there when the input is connected to the cartridge? nt - Ugly 14:09:17 05/31/17 (0)