Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Poll: Do you value / want / use "REC OUT" on your preamp? posted by Andy Tebbe on April 26, 2017 at 09:57:00:
I use the Phono section and a couple of the Line level ins - Normally the selected input (usually one of the 3 phono inputs) go out the Tape Output to to my receiver"Tape in", I send the Tape out from the receiver to send back into the Preamp line section - the RP2 has two sets of buffered outputs post volume knob - one of those drive a mixer that can drive my power amps on my main system in pure analog so I can run a straight analog from Phono to Power amp. The other line ins is from my oppo digital source or my Sound Devices USBpre2 D-A section. The other output of the Preamp goes to a Audio source Amp for hole house audio and a dedicated NAD2150 power amp that drive my outdoor loudspeakers for parties.
"The hardest thing of all is to find a black cat in a dark room, especially if there is no cat" - Confucius
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Poll: Yes, Acoustat RP2A - BigguyinATL 11:31:04 04/28/17 (0)