|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: If it's not buffered..... posted by viridian on April 26, 2017 at 15:23:25:
It doesn't load the output stage of the preamp---it loads the output stage of the audio component currently selected for listening. However, my record output is not buffered and I can detect absolutely no problems whatsoever. My TASCAM DA-3000 is connected to my record output and my system sounds just fine to me.
Best regards,
John Elison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: If it's not buffered..... - John Elison 18:08:16 04/26/17 (10)
- Respectfully disagree, in an unbuffered tape out the.... - viridian 10:46:58 04/27/17 (9)
- You can respectively disagree all you want, but you're wrong... - John Elison 13:11:05 04/27/17 (8)
- Just asking. - Dave Pogue 05:49:17 04/28/17 (7)
- RE: Just asking. - John Elison 06:37:47 04/28/17 (6)
- RE: Just asking. - Dave Pogue 07:53:11 04/28/17 (5)
- RE: Just asking. - John Elison 08:21:44 04/28/17 (4)
- RE: Just asking. - Dave Pogue 09:06:51 04/28/17 (3)
- RE: Just asking. - John Elison 09:26:36 04/28/17 (2)
- "... ten thousand times..." - Dave Pogue 04:49:49 04/29/17 (1)
- RE: "... ten thousand times..." - John Elison 13:39:02 04/29/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]