Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Behringer crossover - should I get it? posted by K-Bob on April 20, 2017 at 12:18:38:
I cannot go back to passive with all my systems, I only use a simple passive on full range drivers but still use active crossovers for sub duty,once dialed in it's awsome,the only negatives are some crossovers have some op amp yucckies,this can be overcome by not using any gain from the crossover or even using transformers for inputs/outputs
go for it and report
Canare makes cheap decent xlr or you can diy
Silence is golden duct tape is silver
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- active rocks - merdy 07:09:54 04/21/17 (0)