Home Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Second guessing my used tube amp purchase...

I recently bought (but have not yet received) a used Raven Nighthawk MK2. The amp is rated at 20wpc, but all the reviews seem to say that it punches above its weight.

I was reading a thread about pairing "low power" tube amps with inefficient speakers, and was a little worried that the Raven would fall a bit short on power for my speakers (Wharfdale 240s, specs below).

Any thoughts while I wait for my new amp? thanks

General description: 3-way floorstanding speaker
Enclosure type: bass reflex
Transducer complement: 3-way
Bass driver: 165mm Woven Kevlar Cone x 2
Midrange driver: 130mm Woven Kevlar Cone
Treble driver: 25mm Soft Dome
AV shield: No
Sensitivity(2.83V @ 1m): 89dB
Recommended amplifier power: 25-150W
Peak SPL: 102dB
Nominal impedance: 4Ω
Minimum impedance: 3.0Ω
Frequency response (+/-3dB): 40Hz - 20kHz
Bass extension (-6dB): 35Hz
Crossover frequency: 470Hz & 2.7kHz


This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Topic - Second guessing my used tube amp purchase... - V01 08:48:55 03/22/17 (19)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.