|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Need Help with Volume Issue (Long) posted by JimC on January 31, 2017 at 14:47:09:
I downloaded the manual for the HAP S1 and I couldn't find anything about its output voltage. Strange! All it said about the line outputs was that they had 2.2-killohms output impedance but there was no mention of output voltage. I suspect they have considerably higher output voltage than 2.2-volts full-scale.
I would recommend playing a test CD through the DAC and measure the output voltage with an AC voltmeter when playing a full-scale 1000-Hz test tone. You might find the HAP S1 has more like 4 or 5-volts at its line level outputs.
Good luck,
John Elison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Need Help with Volume Issue (Long) - John Elison 16:30:33 01/31/17 (2)
- RE: Need Help with Volume Issue (Long) - JimC 19:03:02 01/31/17 (1)
- RE: Need Help with Volume Issue (Long) - John Elison 19:58:12 01/31/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
