|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: REVIEW: Dynaco ST-120 Kit: Wired & Tested Amplifier (Tube) posted by A.Wayne on September 28, 2015 at 07:11:41:
The output transformers on all the VTA amps have multiple secondary taps for 4, 8 or 16 ohms. When you build the amp you just connect either the 4 or 8 or 16 ohm tap to the red binding post depending on the impedance of the speakers you intend to use with the amp. If you do need multiple taps, like BOTH 4 and 8 ohm, they are available (at extra cost).
Bob
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: REVIEW: Dynaco ST-120 Kit: Wired & Tested Amplifier (Tube) - Bob Latino 15:42:06 09/28/15 (2)
- RE: REVIEW: Dynaco ST-120 Kit: Wired & Tested Amplifier (Tube) - pictureguy 15:14:37 06/27/21 (0)
- RE: REVIEW: Dynaco ST-120 Kit: Wired & Tested Amplifier (Tube) - A.Wayne 17:36:39 09/28/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
