|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Changing volume control power amp Altec 9940A posted by Quad2905 on June 6, 2012 at 05:40:26:
"The stock control is a log type, it is too touchy for setting crossover levels."
A log pot at 50% rotation is -20dB, a linear is -6dB.
If you need a fine degree of adjustment over a small range (as when adjusting levels with an electronic crossover) it is easier to use the linear. I was using a passive line-level crossover with no adjustments, so I needed better control than the stock pot offered.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Changing volume control power amp Altec 9940A - djk 13:19:28 06/06/12 (2)
- RE: Changing volume control power amp Altec 9940A - Quad2905 13:25:59 06/06/12 (1)
- RE: Changing volume control power amp Altec 9940A - djk 15:57:37 06/06/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
