Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Weighty Question posted by RogerT on May 1, 2012 at 07:35:49:
Thank you everyone for your ideas. I have found spare foam pieces (the type that new audio gear is packed in) and used it to prop the IEC with great results (the square foam piece was a little low so I shimmed it with extra foam). I then looked at the thread on the cable forum and will now take all cables off the floor and onto foam pieces and make sure that whenever a power cable crosses an interconnect, it's at a 90 degree angle.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- THANKS - RE: Weighty Question - RogerT 15:41:02 05/01/12 (0)