|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: How to set two amps in the same volume level in bi-amping posted by cktc on October 12, 2011 at 12:23:32:
...you just turn the bass amp's level down until you like the sound. There's no such thing as the exactly right level of bass. I imagine that for some recordings you'll want the bass level a little higher and on some, a little lower...and the next guy will like it at 3 or 4 different levels, so just listen and tweak that control to your heart's content.
Enjoy!
Of course, you might find that the bass end of your biamped system has not enough level. If so, you'll have to install level controls in your UF amps(s) to reduce those levels.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Assuming the bass amp has more gain then the upper-frequency (UF) amp... - jeffreybehr 12:38:40 10/12/11 (3)
- Isn't the speakers designed to run by amps with the same gain levels - cktc 12:58:57 10/12/11 (2)
- Yes... but... - Victor Khomenko 11:53:53 10/13/11 (0)
- Indeed. - Kal Rubinson 14:54:23 10/12/11 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
