|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: How to evaluate preamps? posted by tetsuo on May 10, 2007 at 14:15:05:
Various passive attenuators can sound quite different and the same goes for active preamps. You have to try them and listen then choose one that suits your needs.I've had bad passive attenuators and one that was outstanding. Similarly for active linestages, I've had several that were veiled, warm, rolled off, bright, dull, sterile, etc. And a couple that I like very much.
My setup has become more complex over the years with more sources so I gave up the passive linestage for an active solid-state preamp. My system still sounds very good.
Good luck.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Plug 'em in and listen... Not rocket science ! - AbeCollins 08:06:31 05/11/07 (2)
- +1 - Awe-d-o-file 12:20:27 07/22/16 (0)
- Re: Plug 'em in and listen... Not rocket science ! - morricab 16:56:22 05/11/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
