Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Troubleshooting static/crackling noise on power up and power down only posted by posbwp55@msn.com on May 5, 2007 at 11:06:50:
on various occasions, and in most situations it turns out to be a tube. On my personal gear,
it's either been input or driver tubes on
the amp, or often output tubes as well.Take all the tubes from the left channel and swap them for the right.
Swap both driver and output tubes so it doesn't get too complicated to track down.Remember to reset the bias's for the output tubes. If the problem follows the tubes,
then you at least know it's one or more of them from that channel. If not, it's an amp issue.Best of luck,
RFG
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I've seen this problem - RFGumby 12:46:41 05/06/07 (2)
- Re: I've seen this problem - posbwp55@msn.com 17:28:54 05/07/07 (0)
- Re: I've seen this problem - posbwp55@msn.com 16:01:47 05/07/07 (0)