|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Anyone in the Anaheim area? posted by goryu on March 19, 2024 at 05:59:06:
that will likely work with a SPECTRA for disassembly and provide pics along the way. Short version:1. Disconnect from power source and allow several hours for voltage bleed.
2. Remove four sheet metal screws (not bolts) found two on either side of interface.
3. Tilt unit backwards to reveal connections.
4. Unscrew and remove the two color coded signal wires attached by spades to the central HV panel.
5. Pull red bias pin from center. Ideally, short it against one of the other terminals to shunt any stray voltage.
6. Remove screws attaching remaining housing from base.
7. Remove screws attaching panel to base.I've already posted a view of the interface internals where the signal wire terminals (blue/black) and bias pin are located.
Edits: 03/19/24
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I can provide instructions - E-Stat 15:33:09 03/19/24 (1)
- RE: I can provide instructions - goryu 16:35:27 03/19/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
