RE: MGIIIA: solder used to connect ribbon to wires that go to crossover

Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

In Reply to: RE: MGIIIA: solder used to connect ribbon to wires that go to crossover posted by Roger Gustavsson on January 28, 2024 at 08:13:07:

There is a copper/tinned tab at each end of the ribbon that will accept either push-on female 'spade' connectors, or they can be used as solder pads. The ribbon is already connected/soldered to those spade connectors. The tabs where the wires attach will accept standard tin/lead solder, silver solder is not required.
The safer method would be to attach (by crimp or preferably solder) the crossover wires to female spade connectors of the right size, but then you have a non-bonded connection at both ends which are subject to oxidation/conductivity problems.

Edits: 01/29/24

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

Follow Ups Full Thread

Topic - MGIIIA: solder used to connect ribbon to wires that go to crossover - Beardy 14:21:24 01/24/24 (3)

RE: MGIIIA: solder used to connect ribbon to wires that go to crossover - UncleMeat 02:09:08 01/27/24 (2)

RE: MGIIIA: solder used to connect ribbon to wires that go to crossover - Roger Gustavsson 08:13:07 01/28/24 (1)

RE: MGIIIA: solder used to connect ribbon to wires that go to crossover - UncleMeat 23:05:58 01/29/24 (0)

Follow Ups

RE: MGIIIA: solder used to connect ribbon to wires that go to crossover - UncleMeat 23:05:58 01/29/24 (0)

FAQ

Post a Message!

Forgot Password?

Moniker (Username):
Password (Optional):
	Remember my Moniker & Password (What's this?) Eat Me
E-Mail (Optional):
Subject:

Message:	(Posts are subject to Content Rules)

Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:	Automagically notify you when someone responds.

To view your new posting or follow-up, click on the RELOAD or REFRESH button on your browser.