Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Planar Speaker Asylum ]
[ Alert Moderator ]

RE: "Anyone here seen a .7 crossover schematic yet" ...

You DO need to know what the component values are because the crossovers are setup with different filter points for low-pass and high-pass. (This is especially true of the older models with parallel crossovers.)
And, a confirmation measurement of the impedance of the xducers should be incorporated as well.

You can't just select a single crossover frequency for both portions and vary it. You'd end up with a hugely bumped up midrange response.

Dave.


Edits: 11/25/21
This post is made possible by the generous support of people like you and our sponsors:
  McShane Design  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]