In Reply to: Buzz but not delamination? posted by ketchup on May 7, 2021 at 07:05:45:
This happened to my IIIAs, many years ago.
Given the glue failed once ... I didn't want it to fail again. So I drilled a hole through each end of each bar - and through the metal driver-surround - and used 4mm (5/32", in your language!) bolts with a spring-washer, to clamp the bars tight, permanently.
Mind you, if you do this, you need to tape A3 sheets of paper both sides of the driver, to stop drill-scarf from getting onto the mylar or into the holes.
Andy
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Yes, I would say the bar (or several) has become unstuck. ... - andyr 17:40:08 05/07/21 (14)
- RE: Yes, I would say the bar (or several) has become unstuck. ... - ketchup 18:04:41 05/07/21 (13)
- RE: Yes, I would say the bar (or several) has become unstuck. ... - shumi 04:27:02 05/08/21 (1)
- RE: "The plant uses 3M fastbond 30 NF to glue the bars...do not use too much." ... - andyr 05:40:32 05/08/21 (0)
- RE: "Was it just the ends of your bars that became loose " ... - andyr 18:07:38 05/07/21 (10)
- RE: "Was it just the ends of your bars that became loose " ... - Roger Gustavsson 02:54:53 05/08/21 (9)
- RE: "These can come lose, it is just a screw." ... - andyr 05:43:26 05/08/21 (8)
- from the factory - Roger Gustavsson 05:52:34 05/08/21 (7)
- What is the red goop in the tube ??? - emailtim 09:44:52 05/08/21 (5)
- RE: What is the red goop in the tube ??? - ketchup 11:17:41 05/08/21 (4)
- RE: What is the red goop in the tube ??? - pictureguy 22:30:40 05/08/21 (3)
- RE: What is the red goop in the tube ??? - Norman M 10:16:47 05/09/21 (1)
- RE: What is the red goop in the tube ??? - pictureguy 10:44:23 05/09/21 (0)
- RE: What is the red goop in the tube ??? - Roger Gustavsson 01:46:01 05/09/21 (0)
- Wow, it's amazing that those,.. - DustyC 08:07:12 05/08/21 (0)