In Reply to: RE: Bi-Amping Apogee Full Range posted by neolith on December 1, 2020 at 15:51:19:
Another thought - maybe the voltage output of your pre-amp does not match the sensitivity of the amplifier. For example, if your preamp outputs 1.5V and the amp sensitivity is 2V, then you might have an issue. Most CDPs output >2V (typical 2.2-3.5V). Try hooking your CDP directly to the amp and see if this results in adequate SPL.
"Our head is round in order to allow our thoughts to change direction." Francis Picabia
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Bi-Amping Apogee Full Range - neolith 11:10:49 12/02/20 (0)