|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Bypassing fuses on 3.5 posted by meddman@mac.com on September 25, 2020 at 15:21:18:
You can just unscrew the black wire from the (Mid/Tweetet) POSITIVE(+) input post. Leave the eyelet on the black wire (no need to cut it to disconnect it) and just take the whole eyelet off the post.
You can also just move the red eyelet over to the (Mid/Tweeter) POSTIIVE(+) binding post.
You will have to cut or unsolder the green wire to move it (unless that is a spade connector, hard to tell from the picture).
.
2022/03/30 Historical Records CENSORED
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Bypassing fuses on 3.5 - emailtim 15:29:44 09/25/20 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
