In Reply to: Magnepan DWM - Crossover? posted by PaulF70 on September 13, 2020 at 16:55:33:
Use an active crossover at 200Hz (a miniDSP 2x4 would work fine), send below 200Hz to the DWM and above 200Hz to the Quad. You can use one DWM and connect Left/Right to the separate voice coils, or use two DWMs and connect one voice coil each. The internal crossover in the DWM would not be in the picture because I believe it just sends high pass to the high output. I don't think it low passes the below 200Hz.
Agilist, Musician, Photographer, Audiophile
Magneplanar: 3.7, CCR, MC1,LRS, MMGW, DWM; Outlaw: UltraX12, LFM-1C; Emotiva: XMC-2; Nord: Nord One NC500DM, Nord Three 1ET7040SA; Outlaw: Model 7500; OPPO 205
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Magnepan DWM - Crossover? - MarcL 18:08:40 09/13/20 (0)