In Reply to: RE: First Watt B4 arrives today - setup questions for Tymp I-Ds posted by Satie on April 21, 2017 at 22:23:45:
You won't need a level control on the low-pass section because the RC network will create an insertion loss. Even adding one to the high-pass filter section can get a little tricky because it alters the source resistance.
The t-linespeakers link information is not incorrect, but it's much too "textbook." A person will most likely need to adjust the component values because of capacitor standard values, relative attenuation, etc, etc.
Dave.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: First Watt B4 arrives today - setup questions for Tymp I-Ds - Davey 06:40:16 04/22/17 (6)
- RE: First Watt B4 arrives today - setup questions for Tymp I-Ds - BDP24 17:48:43 04/22/17 (5)
- RE: First Watt B4 arrives today - setup questions for Tymp I-Ds - Davey 20:54:10 04/22/17 (4)
- RE: First Watt B4 arrives today - setup questions for Tymp I-Ds - BDP24 00:24:15 04/23/17 (3)
- RE: First Watt B4 arrives today - setup questions for Tymp I-Ds - Davey 07:47:37 04/23/17 (2)
- RE: First Watt B4 arrives today - setup questions for Tymp I-Ds - BDP24 17:45:36 04/24/17 (1)
- RE: First Watt B4 arrives today - setup questions for Tymp I-Ds - Davey 20:55:11 04/24/17 (0)