Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

RE: Tube Bass Traps.

I built 67 of these for my sound room. Forget the brand, but it was simiar to Knauf. Believe the place was Pacific Insulation here in Portland. ASC is 2 hours away, in Eugene. The ware-houseman said they had "a guy" from Eugene that bought the same stuff. I didn't fill them with anything, but I did put a circle of fiberboard 1/3rd of the way inside the tube, with a 1/4" airhole in the middle. I cantered it slightly to break up resonances. The hole is for pressure equalization. Used drummel-cut 1/2 inch pressboard for the ends, liquid nails as adhesive. My recommendations:
* experiment with the thickness of plastic for diffusion on 1/2
* A 4 ft height is much more useful=1 unit would be over ear height
* They hold up for years, but the chicken wire ASC uses adds stability
* Find a shop that will cut the circles for you ! (Pain to do by hand)
They make a huge difference in bass and imaging. Map out your room nodes and consider the lowest frequency that your speakers put out and ear can hear. I initially built 2 helmoltz resonators to address my 22hz fundamental. My Maggie6L's don't go much below 60hz and my ears lose 40 and below. Oops.
"I see sound waves"


This post is made possible by the generous support of people like you and our sponsors:
  Amplified Parts  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.