Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Planar Speaker Asylum ]
[ Alert Moderator ]

RE: Absolutely! ...

Ozzie wrote: "My intention was to go even further than this. I am hoping to rewire the existing tweeter, again in QR with foil from what you would find on the 20.7 mid."

The foil used in the mids of the 20.7 is too wide (0.0005"x0.1") to be a direct replacement for the round wire in the Tympani I-D tweeters. In your case with a ribbon tweeter, it might be a step in the right direction as, in theory, it shifts the original tweeter into a slightly lower register (8 ohm=Tympani I-C and Tympani IIIA). I am using that foil in my T-IVa mids. You could also think about the use of thinner Mylar for your tweeter rebuild.

This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]