Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Planar Speaker Asylum ]
[ Alert Moderator ]

RE: Magnepan 1.6QR Update

I didn't do a pictorial when I made 'em....but it is fairly simple.

I used 2 pair of vice grips...narrow jaw. Step #1 is to measure current jumpers. They 'mic' about 0.151" in diameter. Use a ruler and 'walk' it around the long way.. Cut 4 pieces of BARE copper #6 wire to match. Straighten the wire. I used a flat surface and TAPPED with a hammer. I used a small machinists ball peen style. Bend into the U-shape. You'll need to measure and you may screw up the first wire or so.....trying to guess the radius of the bend. I'm pretty good at that and didn't mess up. I used 2 pair of vice grips.....or maybe a small pair of channel locks? But once bent and vetted to length, go ahead and grip one end with 400 grit and SPIN. This will reduce the diameter to the correct dimension.
I loafed thru making 4 jumpers in maybe just over 1/2 hour.
Pull them annually and resand...and use some DeOxit upon reinstall.
Use the allen wrench to secure 'em.......
Too much is never enough

This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]