|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: PLLXO question related to LDR posted by johnvb on February 26, 2012 at 06:52:39:
I would think a 100k input load would give you too much insertion loss to be practical. However I think this would work for your MMG's.
R-HP = 6190 ohm
C-HP = 1.7 nf
R-LP = 5600 ohm
C-LP = 120 nf (0.12 mfd)
I calculate the insertion loss to be -2db and the minimum input impedance seen by your tube stage is 4740 ohm.
Here's the Bode diagram comparing to stock:
Here's my PLLXO spreadsheet in Open Office.
"Our head is round in order to allow our thoughts to change direction." Francis Picabia
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PLLXO question related to LDR - neolith 09:07:12 02/26/12 (1)
- RE: PLLXO question related to LDR - johnvb 09:28:17 02/26/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
