In Reply to: "When I put sandbags on the top of my boxes which were on the floor"??? ... posted by andyr on February 9, 2012 at 22:31:25:
If the crossovers are sensitive to vibration, you should use other components. There are components that are insensitive to vibration. Many expensive audiophile grade capactiors are way to sensitive! (You can even use some of them as small loudspeakers, connect them in series with a 2-4 Ohm resistor across the output of a poweramp) I like it hardwired as far as possible. Mangepan use too many connectors of low quality. Many of them can be soldered. The banana connectors can be replaced by high quality ones, I prefer the insulated Multi Contact (SEB4-F sockets and SLS425-SW/A or SLS425-SI, depending on the application). Very good fit, not to exepensive and no risk of shorting.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: "When I put sandbags on the top of my boxes which were on the floor"??? ... - Roger Gustavsson 22:55:47 02/09/12 (0)