|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Foil Project for IIIa's posted by computerman on February 1, 2012 at 12:55:45:
computerman wrote:
"We then laid down two separate runs of foil per the suggestion of Roger just the way it was on the matching speaker for the wires. The speaker was a bit different from the picture Roger posted, so we duplicated the matching speaker. We created two sets of + and - connections, so that both runs are parallel. and when finished, I measured the resistance with my Fluke Multimeter. It measured a surprising 4.1 ohms."
"...., but all runs seem to cover the magnets fine."
Some pictures would be nice!
But the foil should be right between the magnets, not over them.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Foil Project for IIIa's - Roger Gustavsson 00:57:58 02/02/12 (2)
- RE: Foil Project for IIIa's - computerman 18:22:39 02/02/12 (0)
- RE: Foil Project for IIIa's - tyu 05:52:50 02/02/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
