In Reply to: RE: "Are your reinforcing bars wood or mdf??" ... posted by Dawnrazor on June 3, 2010 at 19:21:01:
Well, yes I did, DR. :-)) I drilled through the ends of each reinforcing bar (and the driver frame) and used 12mm M4 bolts to clamp the end of the bars to the metal sheet. That way they'll never start to peel away (which is not necessarily true with glue).
Regards,
Andy
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- "did something special with them"?? ... - andyr 19:54:33 06/03/10 (8)
- RE: "did something special with them"?? ... - Dawnrazor 20:09:41 06/03/10 (7)
- "IIRC you also used bolts and a channel to hold your drivers in place??" ... - andyr 01:37:29 06/04/10 (6)
- RE: "IIRC you also used bolts and a channel to hold your drivers in place??" ... - Dawnrazor 22:34:22 06/06/10 (5)
- "I can't tell if that channel is a U channel or a flat piece" ... - andyr 22:49:00 06/06/10 (4)
- I have done it the same way... - Bibo01 02:51:25 06/07/10 (2)
- RE: I have done it the same way... - Dawnrazor 08:09:32 06/07/10 (1)
- RE: I have done it the same way... - Bibo01 09:36:05 06/07/10 (0)
- Got it! That sounds like a great way to do it nt. - Dawnrazor 22:57:10 06/06/10 (0)