In Reply to: RE: Picts posted by R. Jamm on May 28, 2010 at 04:43:23:
As I said before I don't think I will make wood frames for the 2.7s. The sonic difference is getting closer and closer to 0% as the project progresses. I think a couple hundred bucks on wood and a lot of hours in time would be better spent doing another project on my system. If you think about it the whole point of the wood frame beyond aesthetics is to dampen the magnet structure properly because the MDF does not do this as well as real wood. The damplifier is coupling directly to the magnet structure in ways that the wood cannot do because of the nature of the material. damplifier and can cut into very small pieces and put on the pole pieces. You are essentially tackling vibration before you ever get to the driver frame.
As for how I applied the damplifier to my wood MG10s I pull the wood frame apart and applied the damplifier on the metal frame of the driver and then but the wood frame back on.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Picts - Accurus 05:51:42 05/28/10 (0)