In Reply to: Re: Bypassing crossovers? posted by Garold on April 23, 2007 at 14:19:31:
Rip them out if you want to get an active crossover and connect 2 amps directly. I put binding posts directly on the drivers, but that is a major modification. Most would just unhook the crossovers and use the existing tabs and some good wire.Otherwise, if you want to passively bi-amp, you could manke new crossovers and modify them to bi-amp.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Bypassing crossovers? - Dawnrazor 16:17:30 04/23/07 (0)